Ford EcoSport key fob battery

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Find the seam or small slot on the body (often at the end away from the blade) and twist a coin or small flat screwdriver in it until the cover lifts.
3. Swap the coin cell, keeping the same face up as the one you removed, and do not bend the metal contact tab.
4. Clip the body closed, fold the blade, and test the buttons from a few steps away.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Most push-button fobs hide a metal backup key. Press or slide its catch and draw the key out first.
2. Use the slot where the metal key sat. Twist, do not lever hard, and work along the seam until the halves separate.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Snap the halves back together, slide the metal key home, and press each button, then try the start button from the driver's seat.

Ford intelligent access fobs usually have a release for the emergency key. The key blade itself fits the pry slot.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.