Nissan Rogue key fob battery

Key with remote in the head

1. The remote electronics sit in the plastic head of the key itself, so there is no separate fob to open.
2. Many key heads split along the side seam. Start at the small notch and pry a little at a time.
3. Inside you may find a small circuit board in a tray. Lift the board out if the cell is underneath, swap the cell with the same side up, and refit the board.
4. Snap it closed and press each button. The car still starts with a dead remote battery on most of these keys, because the start chip needs no battery.

A CR1620 is 16 mm across and 2.0 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Some flip keys have a screw on the back; others just clip. Remove the screw if there is one, then pry gently at the seam.
3. Take out the old cell, noting which side faced you, and fit the new one the same way.
4. Close it up, check the blade still flips cleanly, and test the buttons at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Most push-button fobs hide a metal backup key. Press or slide its catch and draw the key out first.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

Nissan Intelligent Keys normally hold a mechanical key behind a release knob. With the key out, a small screwdriver in the slot separates the halves.

A CR2025 is 20 mm across and 2.5 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Separate remote fob

1. The remote is a small standalone unit. You will not need to touch the ignition key at all.
2. Look for a screw on the back or a notch on the edge. Remove the screw if present, then twist a coin in the notch to split the case.
3. Swap the cell or cells, keeping the same side up as the old ones.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.