Lexus RX key fob battery

Key with remote in the head

1. This type has the buttons built into the key head. The cell is inside that head, between two clipped halves.
2. Find the seam around the head. Twist a coin or small flat screwdriver in the notch at the blade end or side until the halves part.
3. Inside you may find a small circuit board in a tray. Lift the board out if the cell is underneath, swap the cell with the same side up, and refit the board.
4. Press the head together until it clicks and test the buttons. The transponder chip that lets the car start is separate from the battery, so starting should not change.

A CR1616 is 16 mm across and 1.6 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

A CR2016 is 20 mm across and 1.6 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. The gap left by the metal key usually has a pry point. A slow twist with a thin flat tool (tape on the tip saves the plastic) opens the two halves.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Snap the halves back together, slide the metal key home, and press each button, then try the start button from the driver's seat.

Lexus smart keys usually hide the metal key behind a release button; the cover opens from the notch next to where the key sat.

A CR1632 is 16 mm across and 3.2 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.