Kia Sorento key fob battery

Separate remote fob

1. A separate fob has no key blade inside, so it opens with nothing but a coin or a small screwdriver.
2. Find the slot along the edge and turn a coin in it. Go slowly so the clips do not snap.
3. Swap the cell or cells, keeping the same side up as the old ones.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. The gap left by the metal key usually has a pry point. A slow twist with a thin flat tool (tape on the tip saves the plastic) opens the two halves.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Kia smart keys usually free the mechanical key with a button, and the case opens at the gap it leaves.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Find the seam or small slot on the body (often at the end away from the blade) and twist a coin or small flat screwdriver in it until the cover lifts.
3. Swap the coin cell, keeping the same face up as the one you removed, and do not bend the metal contact tab.
4. Close it up, check the blade still flips cleanly, and test the buttons at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.