Hyundai Venue key fob battery

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Snap the halves back together, slide the metal key home, and press each button, then try the start button from the driver's seat.

Hyundai smart keys usually have a button that releases the mechanical key; a flat tool in the gap then opens the case.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Flip key

1. Fold the blade out so it is out of the way, or keep it folded if your case opens from the side; the battery sits in the plastic body, not the blade.
2. Look along the edge for a notch. A coin turned in that notch usually separates the remote half from the blade half.
3. Lift the cell out with a plastic tool and press in the new one with the + side matching.
4. Clip the body closed, fold the blade, and test the buttons from a few steps away.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.