Chevrolet Volt key fob battery

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Some flip keys have a screw on the back; others just clip. Remove the screw if there is one, then pry gently at the seam.
3. Lift the cell out with a plastic tool and press in the new one with the + side matching.
4. Clip the body closed, fold the blade, and test the buttons from a few steps away.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

On many recent GM smart remotes a button on the side releases the key; the slot at the bottom is where the case opens.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.