Chevrolet Trailblazer key fob battery

Separate remote fob

1. A separate fob has no key blade inside, so it opens with nothing but a coin or a small screwdriver.
2. Turn it over: some older fobs use one small screw, newer ones just clip. Pry at the seam once any screw is out.
3. Swap the cell or cells, keeping the same side up as the old ones.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. The gap left by the metal key usually has a pry point. A slow twist with a thin flat tool (tape on the tip saves the plastic) opens the two halves.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

On many recent GM smart remotes a button on the side releases the key; the slot at the bottom is where the case opens.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.