Chevrolet Spark key fob battery

Flip key

1. Open the flip blade. Never force the hinge sideways, since the spring and pin are the weak part of a flip key.
2. Look along the edge for a notch. A coin turned in that notch usually separates the remote half from the blade half.
3. Swap the coin cell, keeping the same face up as the one you removed, and do not bend the metal contact tab.
4. Clip the body closed, fold the blade, and test the buttons from a few steps away.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Most push-button fobs hide a metal backup key. Press or slide its catch and draw the key out first.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

On many recent GM smart remotes a button on the side releases the key; the slot at the bottom is where the case opens.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.